61 67 120 Removing And Installing/Replacing High-Pressure Nozzle (Housing) Of Headlight Washer System (M/Aerodynamic Kit) On Left

Special Tools Required 

• 13 3 010 HOSE CLIP and/or 13 3 010 HOSE CLIP

Necessary preliminary tasks: 

• Remove bumper trim  . See 51 11 156 REMOVING AND INSTALLING/REPLACING FRONT BUMPER TRIM .

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010  .

Catch any escaping washer fluid if necessary.

Fig 1: Identifying Special Tool (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and feed high-pressure nozzle of headlight washer system (4) out of holder (5).

Raise retaining clip (3) in direction of arrow and detach high-pressure line (2) from high-pressure nozzle of headlight washer system (4).

Installation: 

Keep plug connection for high-pressure nozzle (4) and high-pressure line (2) clean and free from grease.

Make sure high-pressure line (2) is correctly engaged on high-pressure nozzle (4).

Fig 2: Identifying Feed High-Pressure Nozzle & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Guide (6) of high-pressure nozzle (4) must be threaded into associated mounting of holder (5).

Carry out a function test before fitting bumper trim.

If necessary, top up washer fluid.

Replacement: 

Remove spray nozzle (nozzle head).