22 11 001 Replacing Right Engine Mount (N51/N52/N52K/N53)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure engine in installation position . See 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N51) or 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N52) .
Remove underbody protection.
Remove right V-strut (E93 and E88 only). See 51 61 011 REMOVING AND INSTALLING/REPLACING V-STRUT, FRONT AXLE CARRIER, LEFT OR RIGHT .

Release screws (1) and remove engine mount.

Tightening torque. See 22 11 1AZ in 22 11 ENGINE SUSPENSION .

Fig 1: Identifying Engine Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Rubber section (1) of engine mount must point to middle of vehicle.

Fig 2: Identifying Rubber Section Of Engine Mount

Courtesy of BMW OF NORTH AMERICA, INC.