LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 135i 2D Convertible, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Equipment - Repair (E88) >> Floor/Luggage/Engine Compartment Panel >> 51 47 440 Removing And Installing Or Replacing Rear Carpet On Seat Pan

51 47 440 Removing And Installing Or Replacing Rear Carpet On Seat Pan

Necessary preliminary tasks: 

Version with central bass speaker: 

Lever out protective cap (1) on left/right.

Loosen left/right screw (2).

Tightening torque, see 72 11 05AZ in 72 11 SEAT BELTS and 72 11 SEAT BELTS .

Installation: 

Check that spacer bushing (3) and rubber ring (4) are in correct position.

Fig 1: Identifying Spacer Bushing & Rubber Ring
G04752769Courtesy of BMW OF NORTH AMERICA, INC.

Pull back cable (1) with cable holder (2).

If necessary, release side trim panel lower section   in lower covered area.

Feed out carpet (3) and remove.

Installation: 

Make sure openings for air duct and attachment points are correctly positioned.

Fig 2: Identifying Cable With Cable Holder
G05779400Courtesy of BMW OF NORTH AMERICA, INC.