51 24 326 Removing and installing / replacing left tension spring with damper for rear lid

Necessary preliminary tasks:

WARNING: Support rear lid in fully opened position with suitable apparatus. Risk of injury.

Pull off retainer (1) upwards.

Pull off tension spring with damper (2) in inwards direction.

WARNING: The rear lid will drop down if it is not supported.

Fig 1: Pulling Off Tension Spring With Damper

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook tension spring with damper (1) from rear lid hinge (2).

Fig 2: Unhooking Tension Spring With Damper From Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe installation direction: hinge end is identified by means of plastic sleeve (1).

Following parts on the tension spring with damper must not be damaged or missing:

Plastic sleeve
Foam inlay in tension spring

Fig 3: Identifying Parts On Tension Spring With Damper
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Semicircular rubber buffer (2) (from window repair kit) must be fitted to rear lid hinge (3) without end stop (1).

Stick semicircular rubber buffer (2) at spacing (A) on rear lid hinge (3).

A = 65 mm

Semicircular rubber buffer (2) must touch rear lid hinge (3) in area (4) with rear lid open.

Fig 4: Identifying Semicircular Rubber Buffer And Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.