51 22 180 Removing and installing/replacing cover on outside handle

NOTE:

If replacing version with comfort access/CA:

In order to avoid Comfort Access malfunction, use only original BMW paints on the outside handle with electrically non-conducting primer.

New part (from 09/2005) is provided with electrically non-conducting primer.

Necessary preliminary tasks:

Remove trim (2).

Fig 1: Identifying Trim

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protect bore (1) against scratching (risk of corrosion).

Release screw (2).

Installation:

Press cover (3) slightly towards rear when screwing down (gap).

Tightening torque 51 22 8AZ .

Fig 2: Identifying Cover And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove stop pad (1).

Fig 3: Identifying Stop Pad

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Press mounting (2) back, lever out cover (3) at rear and remove in direction of arrow.

Tightening torque 51 22 7AZ .

Fig 4: Identifying Screw And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of cover on outside handle (5) must not be damaged or missing:

Thread
Bridges
Bridges
Screw surface

Fig 5: Identifying Outside Handle Parts
Courtesy of BMW OF NORTH AMERICA, INC.