51 71 412 Removing and installing rear spoiler

Necessary preliminary tasks:

Detach hose in area (1).

Disconnect plug connection (2).

Unclip lines at points (3).

Disconnect plug connection (4).

Press rubber grommet (5) upwards out of rear lid (6).

Installation:

Make sure rubber grommet (5) is correctly seated.

Fig 1: Rubber Grommet, Rear Lid And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out rubber plug (1).

Unscrew nuts (2).

Tightening torque: 51 71 2AZ, see 51 71 SEALS AND LOOSE BODY PARTS

IMPORTANT: Carefully remove rear spoiler (3) in upwards direction from rear lid (4) (with aid of a 2nd person) and place on a clean surface.

Fig 2: Rubber Plug, Nuts And Rear Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Lines may get caught as they are pulled out. If necessary, support lines as the are being fed out.

Installation:

Sealing washers (1) and side buffer stops must not be damaged.

Make sure there is a uniform gap all round.

If necessary, carry out height adjustment of rear spoiler (3) using adjusting screws (2).

Fig 3: Rear Spoiler, Adjusting Screws And Washers

Courtesy of BMW OF NORTH AMERICA, INC.