12 00 ... Instructions for disconnecting and connecting battery
Observe safety instructions for handling vehicle battery. (See 61 00 ... SAFETY INSTRUCTIONS FOR HANDLING VEHICLE BATTERY ).
Before disconnecting battery:
Turn off the ignition and other electrical loads/consumers to prevent sparking when reconnecting.
NOTE:
If the ignition is not turned off when the battery is disconnected, fault memories may be set in some control units.
IMPORTANT:
- There is a danger of mixing up battery leads: If the battery positive and negative leads are the same color and you are in doubt, follow the polarity to the battery, then mark and cover the leads.
- On vehicles with radio code: After disconnecting the battery, the radio code must be re-entered. Therefore obtain the radio code card from the customer beforehand. Note stored stations and restore them after connecting the battery.
- Stored settings of the on-board computer and clock will also be lost.
- All available central keys must be recoded for cars with first generation infrared transmitter locking systems.
General notes on disconnecting battery:
- Do not disconnect battery leads and leads from alternator and starter motor while engine is running.
- Cars with IBS on battery negative terminal:
Do not under any circumstances pull/lever off pole shoes by force.
Do not under any circumstances release socket-head cap screw of IBS.
- Detach terminal of battery negative lead from car battery and second battery if fitted. Cover battery negative terminal(s) and secure. (See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD )
- When work is carried out on the electrical system, faults may be caused in the fault memories of some control units when the battery is connected.
- When installing battery terminal: tightening torque: 61 21 1AZ . (See GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES article).
After connecting battery:
IMPORTANT:
After a power supply interruption some equipment is disabled and must be reactivated.
Please refer to the BMW Progman user documentation for further information on vehicle-specific activation.
Likewise, individual settings are lost and must be activated.
Example:
- Vehicles with build date from 03/2007:
Teach-in mid-position for power steering
- If necessary, activate sliding sunroof .
- If necessary, carry out adjustment of active front steering .
- If necessary, activate power windows . (See 67 62 ... NOTES ON INITIALIZING POWER WINDOW UNIT (FROM 04/2004) ).
- If necessary, activate mirror with compass .
Please refer to the BMW Progman user documentation for further information on vehicle-specific activation.