61 35 015 Removing and installing (replacing) control unit for Car Access System
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection) .
NOTE:
The comfort access system is a radio-based system and can be interfered with by radio waves from other systems (e.g. mobile phone).
Necessary preliminary tasks:
- Remove Decorative Strip On Instrument Panel On Left
- Remove Light Operator Unit
- Remove Trim Panel For Pedal Assembly
Unfasten plug connection (2) and disconnect.
IMPORTANT:
Carefully unlock and disconnect associated plug connection for ribbon cable (1).
Replace ribbon cable (1) if damaged.
The ribbon cable leads to:
- Insert for radio control key
- Start/Stop switch
Release screw (3) and remove control unit for Car Access System (4) in downward direction.
Installation:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.
Replacement:
Carry out Programming/Coding.
Version with independent heating:
Initialize Telestart hand transmitter.