51 45 185 Removing and installing/replacing panel for pedals

WARNING: This page is about a different variant/trim than selected.

Release screws (1).

Pull back trim for pedal assembly (2).

Disconnect associated plug connections and remove trim for pedal assembly (2).

IMPORTANT: Disconnecting the plug connection for the handsfree system speaker results in fault memory entries in the telephone control unit (limitation in the emergency SOS call system).

After fitting, read out fault memory and if necessary delete entries.

Fig 1: Identifying Pedal Assembly Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement (depending on Security version):

Modify Speaker (Park Distance Control)
Modify Footwell Light
Modify MOST direct access bracket
Modify Bluetooth Aerial
Cut out opening for clutch pedal

Fig 2: Identifying Footwell Light, Bluetooth Aerial And Speaker
Courtesy of BMW OF NORTH AMERICA, INC.

Replacement on right-hand drive up to model year 2005:

NOTE: Because of altered locators on side trim panel and trim panel for pedals from model year 2005, the side trim panel must be reworked.

Remove Side Trim Panel (Driver's Side).

Cut off the first three upper ribs (1) on side trim panel (2) flat with a scalpel to contact face (3).

Fig 3: Identifying Ribs, Side Trim Panel And Contact Face

Courtesy of BMW OF NORTH AMERICA, INC.