63 31 175 Removing and installing/replacing door handle light on left or right rear door
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove Rear Door Trim Panel
- Remove Sound Insulation In Rear Door
- Remove Cover On Outside Handle
- Remove Door Lock On Rear Door
NOTE:
Inner door panel partially shown transparent.
Disconnect plug connection (1).
Unclip wiring harness (2) from carrier for outside door handle (3).
Raise outside door handle (4) slightly and remove.
Fig 1: Identifying Plug Connection, Wiring Harness, Out Side Door Handle Carrier And Out Side Door Handle
Installation:
Make sure door handle light (1) is correctly positioned in area (2).
Guides (3) of door handle light (1) must be seated in carrier for outside door handle (4).
Installation:
Make sure wiring harness (1) is laid correctly.
Wiring harness holders (2) must not be damaged.
Replacement:
Do not undo loop (3).