63 31 004 Removing and installing or replacing complete roof light (rear, with module for passenger compartment protection)
Special tools required:
- 00 9 341
Risk of damage!
Carry out operations carefully.
Carefully lever out roof light trim (1) with special tool 00 9 341.
Reflector underneath must not be damaged.
Version with reading lights:
Retainer (1) is on centreline of reading light.
Carefully unlock both retainers (1) on left/right with special tool 00 9 341.
Reflector (2) and roof liner (3) must not be damaged.
Version without reading lights:
Retainer (1) is at distance (A) from outer edge of roof light/reading light.
(A) 3.5 cm
=
Carefully unlock both retainers (1) on left/right with special tool 00 9 341.
Reflector (2) and roof liner (3) must not be damaged.
Lever out ceiling light (1) with special tool 00 9 341
Disconnect plug connection underneath.
Remove ceiling light (1) from roofliner (2).
Installation:
Assemble roof light prior to installation:
- Feed in roof light trim (1) at line (2)
- Press ceiling light trim (1) in direction of arrow onto ceiling light (3)
Make sure roof light trim (1) is correctly seated.
Replacement:
- Remove Module For Passenger Compartment Protection
- If necessary, Convert Bulb .
- Note Bulb Type .