67 16 011 Removing and installing/replacing left vertical aim adjuster (xenon headlight)

WARNING: This page is about a different variant/trim than selected.

WARNING: Version with xenon headlights: Danger to life due to high voltage!

Therefore disconnect all components from voltage supply before removal.

Work on the entire xenon lighting system (control unit, ignition unit with lamp) may only be carried out by specialist personnel.

Necessary preliminary tasks:

NOTE: For purposes of clarity, following illustrations show headlight removed.

Release catches (1) and remove protective cap (2).

Fig 1: Identifying Protective Cap And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Turn vertical aim adjuster (2) to left and feed out of fixture.

Fig 2: Identifying Plug Connection And Aim Adjuster

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide headlight insert (1) upwards in direction of arrow.

Fig 3: Identifying Headlight Insert

Courtesy of BMW OF NORTH AMERICA, INC.

Feed ball head of vertical aim adjuster (1) into mounting (2).

Fig 4: Identifying Vertical Aim Adjuster Ball Head And Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: