00 00 ... Tyres: checking inflation pressure, correcting if necessary (incl. spare wheel), checking external condition, tread depth, pattern

WARNING: This page is about a different variant/trim than selected.

Checking tyre inflation pressure:
- Check tyre inflation pressure in accordance with information plate on B-pillar
- The inflation pressure in the spare wheel must be 0.5 bar higher than the maximum specified value on the information plate
- Initialize Run Flat Indicator
Checking tyre condition:
- Check tread depth of all tyres with tyre tread gauge
- Check tyre tread surfaces and side walls for incisions and foreign particles such as nails or screws
- Check tyre tread pattern for localized flattening and wear on one side; if necessary, carry out wheel/chassis alignment after consulting with customer and issue a separate invoice for this work

NOTE:

For reasons of driving safety, only use tyres of the same type and tread pattern on a single vehicle
Inform customer of any incorrect or worn tyres