64 11 869 Replacing servodrive for blending flap
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
Unfasten plug connection (1) and disconnect.
Release screws (2).
Detach servodrive for blending flap (3) in direction of arrow from heater/air conditioner (4).
Installation:
Place servodrive for blending flap (3) over guide pin (5).