65 83 590 Removing and installing/replacing gyro sensor drive for Car Communication Computer

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release bolts (1).

Remove floor pan (2) towards bottom and set down.

IMPORTANT: Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!

When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.

Fig 1: Identifying Retaining Bolts, Spring Strip And Floor Pan

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).

Fig 2: Identifying Car Communication Computer Gyro Sensor, Mounting Bolt And Plug-In Contact

Courtesy of BMW OF NORTH AMERICA, INC.