65 77 720 Removing and installing (replacing) left B-pillar sensor
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection)
.
WARNING:
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect Battery Negative Lead and cover
- Remove Trim Panel For Door Pillar (Bottom)
Release screw (1).
Loosen screw (2).
Installation:
For tightening torque refer to 65 77 5AZ in 65 77 AIRBAG TRIGGERING CONTROL .
If necessary, remove B-pillar sound insulation (5).
Raise B-pillar sensor (3) slightly through opening in B-pillar and feed out towards rear.
Unfasten plug connection (4) and disconnect.
Remove B-pillar sensor (3) from B-pillar.
Installation:
Establish correct positioning of B-pillar sensor (1) by means of guide pin (2) and screw (3).