67 16 016 Removing and installing/replacing right headlight vertical aim adjuster (xenon headlight)

WARNING: This page is about a different variant/trim than selected.

WARNING: Xenon headlights: Danger to life due to high voltage! Therefore disconnect xenon headlights from the power supply.
Work on the entire xenon lighting system (ignition unit, control unit and lamp) may only be carried out by specialist personnel.

Necessary preliminary tasks:

Remove Wheel Arch cover at front.

NOTE: For purposes of clarity, following illustrations show headlight removed.

Release catches (1) and remove protective cap (2).

Fig 1: Identifying Protective Cap And Catches

G04727718

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Turn vertical aim adjuster (2) to left and feed out of fixture.

Fig 2: Identifying Vertical Aim Adjuster And Plug Connection

G04727719

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide headlight insert (1) upwards in direction of arrow.

Fig 3: Installing Headlight

G04727720

Courtesy of BMW OF NORTH AMERICA, INC.

Feed ball head of vertical aim adjuster (1) into mounting (2).

Fig 4: Identifying Ball Head Vertical Aim Adjuster And Mounting

G04727721

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Adjust Headlights .