32 31 102 Replacing steering spindle sleeve

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Remove Lower Section Of Steering Spindle

After installation:

Carry out Steering Angle Sensor Adjustment/Adjustment For Active Front Steering

Pop sleeve (1) out of bulkhead and press together.

Push steering spindle into steering column.

Remove sleeve (1) from steering column.

Fig 1: Identifying Steering Spindle Pop Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Detach pull-in lug from sleeve and lubricate gap with silicone grease.

Press sleeve together, slide onto steering column, align to opening in bulkhead and insert in bulkhead.

NOTE: To prevent the sleeve from slipping out and to avoid complaints by the customer about noise, make sure that sealing lip (1) on engine compartment side rests against bulkhead all round and sealing lip (2) in inside the car rests against the damping.

Fig 2: Identifying Sealing Lip Between Engine Compartment And Damping

Courtesy of BMW OF NORTH AMERICA, INC.