33 33 101 Replacing two rubber mounts for rear axle carrier (rubber mounts, front)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

If necessary, assemble special tools 33 4 140, 33 4 142 and 33 4 147 as illustrated.

If necessary, position new thrust pieces 33 4 149 with countersunk screws on special tool 33 4 140.

Fig 1: Identifying Special Tool (33 4 140), (33 4 142) And ( 33 4 149)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat top edge of rubber mount with Circo Light.

Fit special tool 33 4 441 on rubber mount in such a way that edge of rubber mount disappears in special tool.

Oil special tool 33 4 436 slightly before use.

Align special tool 33 4 140 by way of openings in rubber mount.

NOTE: Ensure it is correctly supported on bearing bushing of rear axle carrier.

Withdraw rubber mount from bearing bushing with special tools 33 4 436, 33 4 437, 33 4 140 and 33 4 431.

Fig 2: Identifying Special Tools (33 4 436), (33 4 437), (33 4 140) And (33 4 431)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Coat new rubber mount with Circo Light.

Oil special tool 33 4 434 slightly before use.

Assemble special tools 33 4 432, 33 4 433, 33 4 435 and 33 4 434 as illustrated.

Align rubber mount by way of arrow to direction of travel.

Draw in rubber mount as far as it will go.

Fig 3: Identifying Special Tools (33 4 432), (33 4 433), (33 4 435) And (33 4 434)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: