33 32 195 Replacing rubber mount for camber arm in rear axle carrier

Special tools required: 

• 33 4 450
• 33 4 451
• 33 4 452
• 33 4 455
• 33 4 456
• 33 4 461
• 33 4 462
• 33 4 463
• 33 4 464
• 33 4 465
• 33 4 466

Necessary preliminary tasks: 

• Remove Coil Spring 
• Remove Camber Arm From Rear Axle Carrier 

Removing rubber mount: 

Pull out rubber mount with special tools 33 4 462, 33 4 464, 33 4 463, 33 4 466 and 33 4 465.

Fig 1: Identifying Special Tools (33 4 462), (33 4 464), (33 4 463), (33 4 466) And (33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

Installing new rubber mount: 

Pull rubber mount together with special tools 33 4 455, 33 4 456, 33 4 452 and 33 4 451.

Fig 2: Identifying Special Tools (33 4 455), (33 4 456), (33 4 452) And (33 4 451)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount into rear axle carrier so that slot (1), rubber mount centre point and notch (2) form a line.

Fig 3: Identifying Rubber Mount Centre Point Slot Position

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount as far as possible into rear axle carrier with special tools 33 4 461, 33 4 463, 33 4 466 and 33 4 465.

Remove special tool 33 4 450 and draw in rubber mount as far as it will go.

Fig 4: Identifying Special Tools (33 4 450), (33 4 461), (33 4 463), (33 4 466) And (33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• Perform Chassis Alignment Check