33 17 004 Replacing all front rubber mounts for rear differential mounting

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Withdrawing front rubber mount:

Withdraw front rubber mount with special tools 33 3 312, 33 4 161, 33 4 162, 33 4 466 and 33 4 465.

NOTE: Milled recess of special tool 33 4 161 must point upwards to rear axle carrier.

Fig 1: Identifying Special Tools (33 3 312), (33 4 161), (33 4 162), (33 4 466), (33 4 465) And Front Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installing front rubber mount:

IMPORTANT: Coat bearing bushing in rear axle carrier and front rubber mount with Circolight.

Front rubber mount must be aligned by way of slots (1) to vehicle transversal direction.

Fig 2: Identifying Front Rubber Mount Slots

Courtesy of BMW OF NORTH AMERICA, INC.

Insert front rubber mount in special tool 33 4 311.

Align front rubber mount so that side slots (1) line up with marking (M) on tool.

Fig 3: Identifying Front Rubber Mount Side Slots, Marking And Special Tool (33 4 311)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in front rubber mount with special tools 33 4 465, 33 4 466, 33 4 166, 33 4 311 and 33 4 312 as far as it will go.

Fig 4: Identifying Special Tools (33 4 465), (33 4 466), 33 4 166), (33 4 311), (33 4 312) And Front Rubber Mount Mark

Courtesy of BMW OF NORTH AMERICA, INC.