34 41 140 Removing and installing or replacing guide tube for handbrake cables

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

NOTE: After completing work:

Release handbrake lever.

Lock adjuster unit (ASZE).

Using special tool 32 1 030, press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Installation:

Unlock adjuster unit (ASZE).

Lever out restraining hook (2) with a suitable screwdriver.

Restraining hook (2) must detach from stop (1) of adjusting spring.

Fig 1: Identifying Special Tool (32 1 030), Retaining Hook And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Press retainer (1) in balance arm (2) forward in direction of arrow.

Detach handbrake Bowden cables (3) from balance arm (2).

Fig 2: Identifying Handbrake Bowden Cables, Retainer And Balance Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Pull handbrake cables out of guide tube.

Release screws (1).

Release screws (2) and feed out guide tube (3) towards bottom.

Installation:

Replace seal.

For tightening torque refer to 34 41 4AZ in 34 41 PARKING BRAKE .

Fig 3: Identifying Handbrake Guide Tube And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.