65 77 016 Removing and installing/replacing airbag control unit
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection)
.
WARNING:
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect Battery Negative Lead and cover
- Remove Storage Compartment
If necessary, remove foam cover from airbag control unit.
Disconnect plug connection (1).
Release screw (2) and nuts (3).
For tightening torque refer to 65 77 1AZ in 65 77 AIRBAG TRIGGERING CONTROL .
Installation:
Before screwing down airbag control unit (4), make sure negative lead (5) is resting on associated threaded pin.
Remove airbag control unit (4) in direction of arrow.
Replacement:
Carry out programming/coding.