34 41 120 Removing and installing or replacing both handbrake Bowden cables

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

NOTE: After completing tasks, Adjust Handbrake .

Lock adjuster unit (ASZE).

Using special tool 32 1 030, press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Fig 1: Identifying Special Tool (32 1 030), Retaining Hook And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Press retainer (1) in balance arm (2) forward in direction of arrow.

Detach handbrake Bowden cables (3) from balance arm (2).

Fig 2: Identifying Handbrake Bowden Cables, Retainer And Balance Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove holder (2).

Installation:

For tightening torque refer to 34 41 2AZ in 34 41 PARKING BRAKE .

Fig 3: Identifying Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To release the parking brake Bowden cable from the expander lock, it is necessary to Remove The Brake Disk on the following vehicles:

Release one wheel stud.

Bring wheel into position (tapped hole turned down approx. 20° from horizontal).

F = direction of travel

Installation:

Reinstall wheel stud only after handbrake has been adjusted.

For tightening torque refer to 36 10 1AZ in 36 10 WHEELS .

Fig 4: Identifying Wheel Position

Courtesy of BMW OF NORTH AMERICA, INC.

Nipple (1) and expander lock (2) are visible through tapped hole.

Push in core of handbrake cable in direction of expander lock as far as it will go and grip firmly.

Press nipple (1) downwards through tapped hole with a screwdriver.

Pull handbrake cables out of wheel carrier.

Fig 5: Pressing Nipple Downwards Through Tapped Hole With Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert handbrake cable into brake carrier/brake guard plate. Sleeve must be inserted up to stop.

Nipple of handbrake cable must audibly snap into place in expander lock.

Disconnect handbrake cables from holders (1).

Pull handbrake cables towards rear out of guide tube.

Fig 6: Identifying Handbrake Cables

Courtesy of BMW OF NORTH AMERICA, INC.