35 31 000 Removing and installing or replacing clutch pedal

Necessary preliminary tasks: 

• Remove PEDAL TRIM .

Disconnect return spring (1).

Press end of pin (2) together with offset pliers and press out pin.

Detach locking clip (3) and pull clutch pedal off bearing block.

Installation: 

Replace locking clip (3).

Locking clip (3) must be seated with both legs in the pin groove.

Fig 1: Identifying Return Spring And Locking Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Fig 2: Identifying Bearing Bushings

Courtesy of BMW OF NORTH AMERICA, INC.