41 61 000 Hood/Bonnet Removal And Installation

WARNING: This page is about a different variant/trim than selected.

Read contents of Body, General.

Necessary preliminary tasks:

IMPORTANT: For the following work step, secure the engine hood against falling closed.

Disconnect gas-pressure damper from engine hood (1).

Loosen screws (2).

Release screws (3).

For tightening torque refer to 41 61 1AZ.

NOTE: This work step must be carried out with a second person assisting.

Remove hood lid.

Fig 1: Identifying Engine Hood Gas-Pressure Damper And Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.

If this is not possible, Adjust Engine Hood.