41 61 014 Adjusting Engine Bonnet/Hood

WARNING: This page is about a different variant/trim than selected.

Read contents of Body, General.

The specified BODY GAP DIMENSIONS (E90) and BODY GAP DIMENSIONS (E91) serve as the basis for adjustment tasks.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

NOTE: Carry over schematic representation to the relevant vehicle type.

Loosen screws (1) and (2) on left and right hinges.

Hood lid must be able to be moved.

NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Fig 1: Identifying Engine Hood Hinges Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Locks and retaining hook must snap correctly into place.

Adjust engine hood.

NOTE: Vertical Adjustment of engine hood to side panel by means of stop pads.

Fig 2: Identifying Engine Hood Stop Pad Location

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Height adjustment of hood lid to front wall:

Release screw (1) and remove cover (2).

Height adjustment by turning at closing hooks (3).

Fig 3: Identifying Screw, Cover And Hood Closing Hooks

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down all screw connections again.

For tightening torque refer to 41 61 1AZ.

IMPORTANT: Check function of retaining hook.