51 71 447 Removing and installing or replacing panel for cover on left or right side member

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1).

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at holders (2) in direction of arrow and remove.

Fig 2: Identifying Panel And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Before installation, soak holders (1) in water.

If necessary, detach holders (1) from body and fit on panel (3).

If necessary, detach grommets (2) from holders (1) and place on body.

If necessary, replace faulty holders (1) and grommets (2).

Fig 3: Identifying Panel, Grommet And Holder

Courtesy of BMW OF NORTH AMERICA, INC.