52 26 412 Replacing right backrest cover for rear seat

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Release screw (1).

For tightening torque refer to 52 26 04AZ in 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .

Remove outer mount (2).

Fig 1: Identifying Rear Backrest Outer Mount And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover all round with special tool 00 9 317 or screwdriver.

Remove backrest cover with padding from carrier section.

Fig 2: Identifying Backrest Cover And Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding:

Installation:

Insert new retainers with special tool 52 0 050.

In so doing, enclose wire in padding and trim wire of cover.

Fig 3: Identifying Cover And Padding Retainers Mark Area

Courtesy of BMW OF NORTH AMERICA, INC.

Only when replacing seat cover for E90 with build date up to 03/06:

Pull liner off foam strip (1).

Stick on foam strip flush with top edge of padding.

Short protruding foam strip.

Fig 4: Identifying Rear Backrest Foam Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover:

Fig 5: Identifying Cover Trim Wires

Courtesy of BMW OF NORTH AMERICA, INC.