51 13 312 Removing and installing/replacing trim strip on roof gutter at left or right
Necessary preliminary tasks:
IMPORTANT:
Make sure that body is not damaged.
Carry out work with a second person assisting.
Start at front, pull off trim strip (1) in direction of arrow from clips (2).
Installation:
To avoid leaks and noises, check all clips (2) for visible damage.
If necessary, replace faulty clips (2).
Installation:
Make sure seals (1 and 2) are correctly seated on trim strip (3).
Replacement:
Moisten seals (1 and 2) and trim strip (3) with water.
Slide seals (1 and 2) into trim strip (3).
IMPORTANT:
- Carry trim strip by its middle section only (risk of damage)
- Perform installation work with a second person helping
- Prepositioning of trim strip
- Ensure drip molding runs parallel to side frame (risk of breakage)