52 25 010 Removing And Installing/Replacing Left Or Right Rear Seat
Necessary Preliminary Tasks:
- Remove flap in luggage compartment trim panel. Refer to 51 47 172 REMOVING AND INSTALLING/REPLACING FLAP IN LUGGAGE COMPARTMENT TRIM, LEFT OR RIGHT .
- Remove rear head restraint. Refer to 52 24 390 REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT HEAD RESTRAINT (NORMAL) .
- Remove padding for rear seat completely. Refer to 52 25 002 REMOVING AND INSTALLING PADDING FOR LEFT OR RIGHT REAR SEAT .
- Remove rear entrance cover strip. Refer to 51 47 030 REMOVING AND INSTALLING/REPLACING ENTRANCE COVER STRIP, REAR (INSIDE) LEFT OR RIGHT .
- Remove supplementary trim on C-pillar at bottom. Refer to 51 43 240 REMOVING AND INSTALLING/REPLACING SUPPLEMENTARY TRIM ON C-PILLAR AT BOTTOM (WITH ELECTRIC REAR SEAT ADJUSTMENT) ON LEFT OR RIGHT .
- Remove trim for armrest at rear. Refer to 52 25 030 REMOVING AND INSTALLING COMPLETE ARMREST FOR REAR SEAT BACKREST .
Release screw (1) for seat belt, center.
Installation:
For tightening torque refer to 72 11 1AZ in 72 11 SEAT BELTS .
Remove cover (1) upwards out of guide (2).
Detach cover (1) from Velcro-type fastener (5), pull out of guide (4) and lift out completely.
Release screws (3).
Installation:
Insert nuts with Loctite, for tightening torque refer to 52 25 1AZ in SEATS - TIGHTENING TORQUES .
Remove cover (1) towards front.
Release screws (2).
Installation:
For tightening torque refer to 52 25 2AZ in SEATS - TIGHTENING TORQUES .
Disconnect all plug connections and feed out wiring harnesses.
Release screw (1).
Release screw (2).
Installation:
For tightening torque refer to 72 11 20AZ in 72 11 SEAT BELTS .
Lift complete seat with seat frame and set forward slightly.
Feed out belt with tensioner (3) towards rear. Remove complete seat.