66 54 511 Replacing night vision camera

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35 ... NOTES ON ESD PROTECTION STATIC DISCHARGE) .

Necessary Preliminary Tasks:

Release screw (1) on both sides.

Remove camera (2) from holder (3).

Fig 1: Locating Night Vision Camera Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert camera (1) in holder (2).

Left guide pin (3) must be correctly seated in holder (2).

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 2: Identifying Left Guide Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Tab (1) must snap noticeably into holder (2).

Make sure guide pin (3) is correctly seated in holder.

Apply screw securing adhesive to screw (4) and tighten screw.

Installation:

Fig 3: View Of Night Vision Camera In Holder

Courtesy of BMW OF NORTH AMERICA, INC.