65 90 550 Replacing CD/DVD drive for navigation computer

Special Tools Required: 

• 00 9 318

Comply with notes and instructions on handling navigation computers. Refer to 65 90... NOTES ON HANDLING NAVIGATION COMPUTERS 

Replace the destroyed seal on all devices with the new seal supplied.

Necessary Preliminary Tasks: 

• Remove navigation computer. Refer to 65 90 510 REMOVING AND INSTALLING/REPLACING NAVIGATION COMPUTER WITH CD-DRIVE .

MK II Version: 

Cut through seal (1).

Release screws (2) on both sides and carefully fold down front panel (3).

Installation: 

Replace the destroyed seal with the new seal supplied.

Fig 1: Locating Drive Cover Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Lever cover (1) with special tool 00 9 318 upwards out of side catches.

Fig 2: Removing Cover Using Wedge

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and carefully lift out CD drive (2).

Fig 3: Identifying CD Drive Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

MK III And MK IV Versions: 

Cut through seal (1).

Carefully lever off cover (2) with special tool 00 9 318.

Installation: 

Replace the destroyed seal with the new seal supplied.

Fig 4: Removing Cover Using Wedge

Courtesy of BMW OF NORTH AMERICA, INC.

MK III Version: 

Release screws (1) and carefully lift out drive (2).

Fig 5: Identifying CD Drive Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and remove drive (2).

Fig 6: Locating CD Drive Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

MK IV Version: 

Release screws (1).

Carefully lift out DVD drive (2).

Fig 7: Identifying DVD Drive Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and remove DVD drive (2).

Fig 8: Locating DVD Drive Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.