67 66 013 Removing and installing/replacing drive unit for lumbar support on left or right front seat (sports seat)

Detach backrest cover (1) from backrest frame (2).

Fig 1: Detaching Backrest Cover From Backrest Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Detach transparent hose (2) from valve housing (3).

NOTE: If necessary, gently heat transparent hose (2) if firmly seated.

If necessary, detach fabric adhesive tape (4).

Fig 2: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Detach drive unit for lumbar support (5) with jacket towards rear.

Installation:

Clean adhesive area (1) on backrest frame (2).

Fig 3: Identifying Clean Adhesive Area On Backrest Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Transparent hose (1) of drive unit for lumbar support must not be kinked.

Pull off protective film (3) from jacket (2). Stick drive unit for lumbar support to backrest frame.

If necessary, secure jacket (2) with cable strap.

Fig 4: Pulling Off Protective Film From Jacket

Courtesy of BMW OF NORTH AMERICA, INC.