52 13 198 Removing and installing / replacing rear panel on left or right front seat backrest (normal/manual)

Release clips (1) with side cutting pliers.

NOTE: Remove clip remainders.

Fig 1: Releasing Clips With Side Cutting Pliers

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully pull cover (1) with piping (2) out of groove in rear panel (3).

Fig 2: Removing Cover With Piping Out Of Groove In Rear Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

The cover piping (1) has a marking (2) which must line up with hole (3) in rear panel groove (4).
From marking (2), press in piping (1) completely to left and right at bottom.
Five new repair clips must be fitted after each disassembly.

Fig 3: Aligning Cover Piping With Hole In Rear Panel Groove
Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1) (cut through with side cutting pliers).

NOTE: Remove clip remainders.

Fig 4: Releasing Clips (Cut Through With Side Cutting Pliers)

Courtesy of BMW OF NORTH AMERICA, INC.

Pull rear panel (1) off backrest cover (2).

Fig 5: Removing Rear Panel Off Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Holes (1) and (2) on rear panel (3) must not be damaged.

Fig 6: Identifying Holes On Rear Panel
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide backrest cover (1) on left/right over clip mount (2).

Fig 7: Sliding Backrest Cover On Left/Right Over Clip Mount
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

To prevent noise:
Stick felt strip (1) to raised frame area (2).

Fig 8: Sticking Felt Strip To Raised Frame Area
Courtesy of BMW OF NORTH AMERICA, INC.