54 12 136 Removing and installing / replacing headliner for glass slide/tilt sunroof cover

WARNING: This page is about a different variant/trim than selected.

Installation:

If necessary, apply light coat of Renax GL1 (Fuchs) grease to guide duct.

Removing left and right rubber gaiter for glass slide/tilt sunroof cover,

Move mechanism into zero setting.

Slowly pull headliner forwards as far as it will go.

Fig 1: Pulling Headliner

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten left/right screws (1).

Fig 2: Unfastening Left/Right Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Lift headliner upwards to remove.

Fig 3: Removing Headliner

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert headliner (1) in support (2) from behind/left.

Fig 4: Inserting Headliner In Support

Courtesy of BMW OF NORTH AMERICA, INC.