54 13 150 Removing and installing rear cross-member

Necessary Preliminary Tasks: 

• Remove glass slide/tilt sunroof. Refer to 54 13 080 REMOVING AND INSTALLING COMPLETE GLASS SLIDE/TILT SUNROOF  .
• Remove drive omitted. Refer to 67 61 515 REPLACING DRIVE WITH GEAR (FRONT) FOR ACTUATING SLIDE/TILT SUNROOF (PANORAMA GLASS SUNROOF) .

Release screws in marked area.

Feed cross-member (2) out of wiring harness (1) during removal.

Fig 1: Identifying Cross-Member And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Pitch cables must be correctly laid diagonally in guide.