67 61 515 Replacing drive with gear (front) for actuating slide/tilt sunroof (panorama glass sunroof)
WARNING: This page is about a different variant/trim than selected.
Necessary Preliminary Tasks:
- E53 : Remove mounting bracket from roofliner at front. Refer to 51 44 020 REMOVING AND INSTALLING/REPLACING BRACKET ON ROOF LINING AT FRONT .
NOTE:
Secure drive with gear for actuating slide/tilt sunroof (2) against falling out.
Release screws (1), tightening torque, (2.8 N.m.).
Lower drive with gear for actuating slide/tilt sunroof (2).
NOTE:
Screws (1) are microencapsulated.
Unlock plug connection (3), disconnect and remove drive with gear for actuating slide/tilt sunroof (2).
Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).
Installation:
Initialize slide/tilt sunroof. Refer to 54 0 ... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .