52 26 411 Replacing backrest cover for rear seat (through-loading system) on left

WARNING: This page is about a different variant/trim than selected.

Release screw on seat outer mount.

Fig 1: Identifying Screw On Seat Outer Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Screw down screw (1), cover (2), plastic washer (3) and washer (4) as illustrated.

Fig 2: Installation Sequence Of Screw Components

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew seat center mount.

Fig 3: Unscrewing Seat Center Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip and remove cover.

Fig 4: Unclipping And Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Remove trim.

Fig 5: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Separate webbing.

Fig 6: Separating Webbing

Courtesy of BMW OF NORTH AMERICA, INC.

Lever cover with trim wires (1) out of metal clutches (2).

Fig 7: Identifying Metal Clutches

Courtesy of BMW OF NORTH AMERICA, INC.

Detach cover all around by levering out piping (1).

Fig 8: Detaching Cover From Piping

Courtesy of BMW OF NORTH AMERICA, INC.

Detach trim wire (1) from rear panel.

Fig 9: Detaching Trim Wire From Rear Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement, "Padding":

Note clip positions.

Cut through or bend open all clips, remove remnants of clips from cover and padding.

Fig 10: Removing Clips From Cover And Padding

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lock new clips by bending with special tool 52 0 050.

Replacement Only, "Backrest Cover":

Remove all trim wires from cover.

Cut new cover and insert the trim wires.

Fig 11: Removing Trim Wires From Cover

Courtesy of BMW OF NORTH AMERICA, INC.