11 21 500 Replacing crankshaft (M62): Installation
WARNING: This page is about a different variant/trim than selected.
Shrink-fit sprocket wheel to crankshaft.
Check wedge for correct position.
Heat sprocket wheel with a hot-air blower or on a heating plate to max. 150° C.
CAUTION:
Do not exceed specified temperature!
Replace main crankshaft bearing shells,
refer to 11 21 531 REPLACING MAIN CRANKSHAFT BEARING SHELL (M62) .
Replace conrod bearing shells,
refer to 11 24 571 REPLACING ALL CONROD BEARINGS (M62) .
Replace deep-groove ball bearings in crankshaft,
refer to 11 21 571 REPLACING GROOVED BALL BEARING IN CRANKSHAFT (M62 / S62) .