Height Setting
- Load vehicle with a minimum of 441 lbs. (200 kg), 551 lbs. (250 kg) for vehicles with towbar fixture, in center of trunk.
- Place rear wheels on turntable of wheel alignment unit. Secure front wheels. Move shift lever into neutral and release handbrake.
- Measure actual height setting (A) between lower edge of wheel arch (1) and rim flange (2) at height of center of wheel. See Fig 1 . Actual height must be a minimum (15 mm) below the nominal setting. See RIDE HEIGHT SPECIFICATIONS table.
- Start engine. After completion of control procedure (approximately 1 minute), switch off engine. If actual height is above or below the nominal height setting, the vehicle height setting must be adjusted. See HEIGHT SETTING under ADJUSTMENTS.
RIDE HEIGHT SPECIFICATIONS
| Application | In. (mm) | |
|---|---|---|
| Standard Suspension | ||
| 16" Rim | 22.4 (569) | |
| 17" Rim | 23.0 (584) | |
| 18" Rim | 23.5 (597) | |
| Low-Slung Sport Suspension | ||
| 16" Rim | 22.4 (569) | |
| 17" Rim | 23.0 (584) | |
| 18" Rim | 23.5 (597) | |
| Rough Road Package Without Ride Level Control | ||
| 16" Rim | 23.2 (589) | |
| 17" Rim | 23.8 (604) | |
| 18" Rim | 24.3 (617) | |
| Rough Road Package With Ride Level Control | ||
| 16" Rim | 22.4 (569) | |
| 17" Rim | 23.0 (584) | |
| 18" Rim | 23.5 (597) | |