LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1970 >> 2002 _NA_, Standard Trans >> Repair and Diagnosis >> Transmission >> Clutches - (4 Cylinder Engine) Hydraulic Clutch >> Removal & Installation >> Clutch Slave Cylinder

Clutch Slave Cylinder

  1. Siphon brake fluid out of clutch master cylinder reservoir until level is below "MIN" line. Pull retaining ring back on slave cylinder and remove circlip.
  2. Remove line from master cylinder and pull slave cylinder out toward front. To install, reverse removal procedure. Bleed hydraulic system. See HYDRAULIC SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals