LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1970 >> 2002 _NA_, Standard Trans >> Repair and Diagnosis >> Transmission >> Clutches - (4 Cylinder Engine) Hydraulic Clutch >> Removal & Installation >> Clutch Master Cylinder

Clutch Master Cylinder

  1. Siphon brake fluid out of clutch master cylinder reservoir until level is below "MIN" line. Pull topping up line out of master cylinder and disconnect line to slave cylinder.
  2. Pull carpet away from around pedal and disconnect master cylinder push rod from pedal assembly. Remove master cylinder retaining bolts and remove cylinder.
  3. To install clutch master cylinder, reverse removal procedure. Make sure sealing plug is installed on topping up line and bleed hydraulic system. See HYDRAULIC SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals