Overview - Input Shaft 2
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Sensor Wheel
- Pay attention to the installation position
- Always replace after removing
- Removing and Installing. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
- Circlip
- Selecting thickness. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
- Thrust Washer
- For 4th gear assembly
- Inner Race/Needle Bearing
- For 4th gear assembly
- Removing and installing. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
- Needle Bearing
- For 4th gear assembly
- 4th Gear Assembly
- Synchronizer Ring for 4th Gear
- Replace if there are grooves or scoring
- Do not interchange with the synchronizer ring for 6th gear
- Locking Collar for 4th and 6th Gears
- Installation position: the labeled side of the locking collar faces the 4th gear assembly
- Synchronizer Hub for 4th and 6th Gears
- Installation position: the labeled side of the synchronizer hub faces the 4th gear assembly
- Removing and installing. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
- Thrust Piece
- Quantity: 3
- Synchronizer Ring for 6th Gear
- Replace if there are grooves or scoring
- Do not interchange with the synchronizer ring for 4th gear
- 6th Gear Assembly
- Needle Bearing
- For 6th gear assembly
- Inner Race/Needle Bearing
- For 6th gear assembly
- Removing and installing. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
- Thrust Washer
- For 6th gear assembly
- Input Shaft 2
- with splines for the 2nd and reverse gears
- Removing and Installing. Refer to GEAR SET, DISASSEMBLING AND ASSEMBLING .
- Disassembling and Assembling. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .
- Circlip
- For securing on the bearing bracket
- Determine the circlip thickness. Refer to INPUT SHAFT 2, DISASSEMBLING AND ASSEMBLING .