Overview - Gear Set
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Oil Pipe
- Bolt
- M6 x 30
- Always replace after removing
- 3 Nm + 90°
- Gear Actuator
- Transmission Input Speed Sensor 1 and Transmission Input Speed Sensor 2
- Gear Position Distance Sensor 1 G487, Gear Position Distance Sensor 2 G488, Gear Position Distance Sensor 3 G489 and Gear Position Distance Sensor G490 for gear actuators
- Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Always replace after removing
- Oil Pan
- Always replace after removing
- Bolt
- M6 x 30
- Always replace after removing
- 3 Nm + 90°
- Seal
- Always replace after removing
- Hydraulic Pressure Reservoir
- Bolt
- M6 x 30
- Always replace after removing
- 3 Nm + 90°
- Gear Set
- Refer to GEAR SET, REMOVING AND INSTALLING
- Refer to Gear Set, Disassembling and Assembling .
- Bolts
- For gearshift rails of the gear actuator module
- M6 x 50
- 6 Nm + 30°
| Step | Bolts (replace after removal) | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1- through -8- | 3 Nm |
| 2 | -1- through -8- | 90° |