Overview - Bearing Bracket
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Circlip
- Shaft
- For reverse gear intermediate sprocket
- Thrust Washer
- For reverse gear intermediate sprocket
- Reverse Gear Intermediate Sprocket
- Needle Bearing
- For reverse gear intermediate sprocket
- Bolts
- Always replace after removing
- 8 Nm + 90°
- Retaining Plate
- For input shaft ball bearing
- Input Shaft Ball Bearing
- Bearing "C"
- Pay attention to the installation position
- Removing and installing. Refer to Bearing Bracket, Disassembling and Assembling .
- Locking Sleeves
- Quantity: 4
- Removing and installing locking sleeves A and B. Refer to Gear Set, Disassembling and Assembling .
- Removing and installing locking sleeves C and D. Refer to Bearing Bracket, Disassembling and Assembling .
- Gearshift Rail/Fork for Gear 2 & Reverse Gear
- Gearshift Rail/Fork for Gear 4 & 6
- Mounting Bracket
- for gearshift rail/fork for gear 4/6 and gearshift rail/fork for gear 5 and 7
- Bolt
- 6 Nm + 30°
- Gearshift Rail/Fork for Gear 5 & 7
- Gearshift Rail/Fork for Gear 1 & 3
- Circlip
- Pay attention to the installation position
- Output Shaft Ball Bearing
- Bearing "G"
- Pay attention to the installation position
- Removing and installing. Refer to Bearing Bracket, Disassembling and Assembling .
- Bearing Bracket