Left Coolant Pipe, Removing And Installing, 2.9L Engine: Removing

-- Support the engine in the installation position (refer to ENGINE, SUPPORTING IN INSTALLATION POSITION ) and pretension it with the Engine Support Bridge - Spindle :10-222A/11  until the pressure on the left engine mount is released.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Place the Shop Crane - Drip Tray :VAS 6208  underneath.

Courtesy of AUDI OF AMERICA, LLC

-- Clamp off the coolant hose -3- using the Hose Clamps - Up To 25mm :3094  .

-- Loosen the hose clamp -1-, then clamp off the coolant hose with the Hose Clamps - Up To 25mm :3094  and then remove.

-- Loosen the hose clamp -2- and remove the coolant hose.

-- Remove the nuts -arrows- and remove the coolant pipe toward the front to do so slightly lift the engine.