Engine, Supporting In Installation Position

Special tools and workshop equipment required 

• Engine Support Set :10-222 B 
  Fig 1: Engine Support Bridge 10-222A

  Courtesy of AUDI OF AMERICA, LLC
• Engine Support - Supplement Kit :T40093A 
  Fig 2: Engine Support - Supplement Kit T40093A

  Courtesy of AUDI OF AMERICA, LLC

Procedure 

-- Install the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Position the Engine Support Bridge :10-222A  at the left and right side on the longitudinal member.

Courtesy of AUDI OF AMERICA, LLC

-- Engage the Engine Support Bridge - Spindle :10-222A/11  at the left and right on the engine lifting eyes.

-- Tension the engine with the spindles slightly until the engine mount is not under a load.

Assembling

Assemble in the reverse order of removal. Note the following:

-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .