Outer Rear Three-Point Seat Belt, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount in direction of -arrow- and tighten the bolt.
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Connect the connector -1- to the seat belt igniter.
-- Press in the connector lock -2- in direction of -arrow-. While doing this, the connector is pushed into the seat belt igniter all the way and locks into place.
Conditions
- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
- Make sure the connectors are pushed in all the way and that they engage audibly.
Pyrotechnical components can deploy unexpectedly.
A risk of injury is possible.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .