Thorax Airbag Crash Sensor In The Driver/Front Passenger Side B-Pillar G1101/G1102, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Attach the connector -1- to the crash sensor until it clicks into place in direction of -arrow-.
-- Press in the connector lock -2-.
Conditions
- Make sure the wires are not pinched.
CAUTION:
Pyrotechnical components can deploy unexpectedly.
A risk of injury is possible.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .